Differences

This shows you the differences between two versions of the page.

--- projects:plotter [2025/07/16 19:38] – ava
+++ projects:plotter [2025/07/19 13:55] (current) – ava
@@ Line 3: / Line 3: @@
 # Sketchy (Ender 3 Plotter)
-{{:undefined:plotter-action.jpeg?direct|}}
+[{{:undefined:plotter-action.jpeg?direct&650|Sketchy mid-print}}]
-Accessible at http://plotter.local
+Accessible at http://plotter.local on the hackspace network.
 ## Setting up the plotter
-{{:projects:setup_plotter.jpeg?direct&400|}}
+[{{ :projects:plotter_setup.jpeg?direct&200|Sketchy correctly set up with a pen. Don't forget to remove the lid :3}}]
 - Consider levelling the bed. Currently this is a manual process.
@@ Line 16: / Line 16: @@
 - Unscrew the M3 bolts on the toolhead.
 - Put a pen in the toolhead and allow it to touch the paper.
+  - we've found good results from a Uni PIN 0.3mm, but you can experiment with all sorts of implements!
 - Tighten the M3 bolts, you'll want to use a decent amount of torque to ensure the pen doesn't wobble left-to-right as the plotter prints.
@@ Line 26: / Line 27: @@
 ## Uploading and printing
-You can upload your generated gcode to the printer via http://plotter.local as usual. It's a good idea to secure your paper, for example using masking tape.
+You can upload your generated gcode to the printer via http://plotter.local as usual. It's a good idea to secure your paper, for example using masking tape or bulldog clips.
+---
+# Parts
+## Toolhead
+The toolhead is designed by [[user>zoemaestra]], and you can find the STL files [on Printables](https://www.printables.com/model/1354303-ender-3-pen-plotter-toolhead).