Differences

This shows you the differences between two versions of the page.

--- projects:plotter [2025/07/16 19:33] – document setup ava
+++ projects:plotter [2025/07/16 21:24] (current) – ava
@@ Line 1: / Line 1: @@
 <!DOCTYPE markdown>
-# Ender 3 Plotter
+# Sketchy (Ender 3 Plotter)
-{{:undefined:plotter-action.jpeg?direct|}}
+[{{:undefined:plotter-action.jpeg?direct&650|Sketchy mid-print}}]
 Accessible at http://plotter.local
-todo more details on how to use it and shit
 ## Setting up the plotter
+[{{ :projects:plotter_setup.jpeg?direct&200|Sketchy correctly set up with a pen. Don't forget to remove the lid :3}}]
 - Consider levelling the bed. Currently this is a manual process.
@@ Line 16: / Line 16: @@
 - Unscrew the M3 bolts on the toolhead.
 - Put a pen in the toolhead and allow it to touch the paper.
+  - we've found good results from a Uni PIN 0.3mm, but you can experiment with all sorts of implements!
 - Tighten the M3 bolts, you'll want to use a decent amount of torque to ensure the pen doesn't wobble left-to-right as the plotter prints.
@@ Line 23: / Line 24: @@
 Make sure that you have correctly set your working Z-height for your pen, and have set the right x/y starting/ending points. It's a good idea to double check this by moving the toolhead in mainsail to reasonable starting/end points (lower left, upper right).
+## Uploading and printing
+You can upload your generated gcode to the printer via http://plotter.local as usual. It's a good idea to secure your paper, for example using masking tape.