Differences

This shows you the differences between two versions of the page.

--- projects:plotter [2025/07/14 20:26] – created ava
+++ projects:plotter [2025/07/19 13:55] (current) – ava
@@ Line 1: / Line 1: @@
 <!DOCTYPE markdown>
-# Ender 3 Plotter
+# Sketchy (Ender 3 Plotter)
-Accessible at http://plotter.local
+[{{:undefined:plotter-action.jpeg?direct&650|Sketchy mid-print}}]
+Accessible at http://plotter.local on the hackspace network.
+## Setting up the plotter
+[{{ :projects:plotter_setup.jpeg?direct&200|Sketchy correctly set up with a pen. Don't forget to remove the lid :3}}]
+- Consider levelling the bed. Currently this is a manual process.
+- Put a scrap piece of paper on the bed of the plotter.
+- Set the printer's Z co-ordinate to 0.
+- Unscrew the M3 bolts on the toolhead.
+- Put a pen in the toolhead and allow it to touch the paper.
+  - we've found good results from a Uni PIN 0.3mm, but you can experiment with all sorts of implements!
+- Tighten the M3 bolts, you'll want to use a decent amount of torque to ensure the pen doesn't wobble left-to-right as the plotter prints.
 ## Generating gcode
-You can use [this inkscape extension](https://github.com/averymcnab/gcodeplot-klipper) to generate gcode from an svg. There's a good tutorial on how to use this extension [here](https://github.com/AndrewSink/pltr_toolhead/blob/main/pltr%20v2%20User%20Guide%20Rev%20C.2.pdf).
+You can use [this inkscape extension](https://github.com/averymcnab/gcodeplot-klipper) to generate gcode from an svg. There's a good tutorial on how to use this extension towards the bottom of [this PDF](https://github.com/AndrewSink/pltr_toolhead/blob/main/pltr%20v2%20User%20Guide%20Rev%20C.2.pdf).
+Make sure that you have correctly set your working Z-height for your pen, and have set the right x/y starting/ending points. It's a good idea to double check this by moving the toolhead in mainsail to reasonable starting/end points (lower left, upper right).
+## Uploading and printing
+You can upload your generated gcode to the printer via http://plotter.local as usual. It's a good idea to secure your paper, for example using masking tape or bulldog clips.
+---
+# Parts
+## Toolhead
+The toolhead is designed by [[user>zoemaestra]], and you can find the STL files [on Printables](https://www.printables.com/model/1354303-ender-3-pen-plotter-toolhead).