Differences

This shows you the differences between two versions of the page.

--- projects:beeg_plotter [2026/02/07 23:29] – Add config for prusaslicer ava
+++ projects:beeg_plotter [2026/02/07 23:34] (current) – ava
@@ Line 19: / Line 19: @@
 ## Generating gcode
-Beeg Plotter requires gcode instructions to draw, which likely will be generated from an svg. There are a couple of ways to generate gcode for Beeg:
+Beeg Plotter requires gcode instructions to draw, which likely will be generated from an svg. There are a couple of ways to generate gcode for Beeg.
-- Inkscape with [gcodeplot-klipper](https://github.com/averymcnab/gcodeplot-klipper)
-  - good for simple plots with thin lines
-  - see below for example settings
-- PrusaSlicer
-  - recommended for plots with any infill/width
-  - has a measly 1200x1200mm bed size limit
 ### Inkscape
+You can generate gcode from Inkscape with [gcodeplot-klipper](https://github.com/averymcnab/gcodeplot-klipper).
+Inkscape with this plugin is good for simple plots with thin lines. See appendix below for example settings.
 ### PrusaSlicer
-{{ :projects:plotter_prusaslicer_configs.ini |}}
+PrusaSlicer is recommended for plots with any infill/width. Note: has a measly 1200x1200mm bed size limit.
+[Config bundle for PrusaSlicer](https://wiki.glashack.space/lib/exe/fetch.php?media=projects:plotter_prusaslicer_configs.ini).
 ---
@@ Line 53: / Line 51: @@
 ## Config changes
-Config changes will cause an auto backup to [[https://github.com/glasgowhackerspace/beeg-plotter-configs|the beeg config repo]] so if it breaks or gets wiped, you should restore it from there. If you do make big changes, please announce it on the discord.
+Klipper config changes will cause an auto backup to [the beeg config repo](https://github.com/glasgowhackerspace/beeg-plotter-configs) so if it breaks or gets wiped, you should restore it from there. If you do make big changes, please announce it on the discord.